Re: [squid-users] hi

try localhost port_number , without the semi-colon.
for me that worked.

regards,
vijay

----- Original Message -----
From: Ulrich Walcher <uw@walcher.co.at>
To: Arindam Haldar <arindam@d2visp.com>; <squid-users@squid-cache.org>
Sent: Sunday, June 09, 2002 10:15 PM
Subject: RE: [squid-users] hi

> Hi,
> "http_port" sets the port squid is listening on,
> "http_access" is in the acl's, but I guess you meant "http_port 3128".
> What's the use of trying to specify "localhost:3128"?
> Where elst should squid listen than on localhost?
> Cheers, Uli
>
>
> -----Original Message-----
> From: Arindam Haldar [mailto:arindam@d2visp.com]
> Sent: Sunday, June 09, 2002 5:52 PM
> To: squid-users@squid-cache.org
> Subject: [squid-users] hi
>
>
> hi all,
> i started squid sucessfully with this option -->
> http_port localhost:3128
>
> & then tried to preroute with the following command
> iptables -A PREOUTING -t nat -i eth1 -s <ip> -p 6 --dport 80 -j DNAT
> --to-source 127.0.0.1:3128
> but failed to allow clients to use squid cache... i then tried
> iptables -A PREOUTING -t nat -i eth1 -s <ip> -p 6 --dport 80 -j
> REDIRECT
> --to-port 3128
> & still failed !
> i then changed the squid conf to what it was earlier --> http_access
> 3128
> & with this things started workig fine.
>
> what did i miss while trying to start squid with localhost option ?
> thanking in advance
> A.H
>
>
>
Received on Mon Jun 10 2002 - 06:19:19 MDT