RE: [squid-users] Configuring ICAP with Squid 3.0 Pre7

Also when I verified the cache.log file it says "2007/09/11 12:48:26|
essential ICAP service is down after an options fetch failu
re: icap://redhat4up4.sse.com:1344/respmod [down,!opt]".

Regards,
Shailesh

-----Original Message-----
From: Shailesh Mishra [mailto:shailesh_mishra@symantec.com]
Sent: Tuesday, September 11, 2007 12:05 PM
To: Christos Tsantilas
Cc: squid-users@squid-cache.org
Subject: RE: [squid-users] Configuring ICAP with Squid 3.0 Pre7

Thanks a lot for your prompt response Christos, it worked.

Another issue I am facing currently on the similar line is, when I am
modifying the squid.conf file to have following entries:-

icap_enable on
icap_preview_enable off
icap_send_client_ip off
#icap_service s1 reqmod_precache 0 icap://172.16.43.39/reqmod
icap_service s1 respmod_precache 0 icap://172.16.43.39/respmod
icap_class c1 s1
acl HTTP proto HTTP
acl GET method GET
icap_access c1 allow HTTP GET

Squid starts fine but while accessing any web page from the client it
returns error saying "ICAP Protocol Error". "System returned [no error]"

Possible ICAP communication failure?. Is there anything else I am
missing here.

Regards,
Shailesh

-----Original Message-----
From: Christos Tsantilas [mailto:christos@chtsanti.net]
Sent: Monday, September 10, 2007 9:38 PM
To: Shailesh Mishra
Cc: squid-users@squid-cache.org
Subject: Re: [squid-users] Configuring ICAP with Squid 3.0 Pre7

Hi Shailesh,

Shailesh Mishra wrote:
> http://www.squid-cache.org/Versions/v3/3.0/ . After executing the
> command in the following manner:-
> 1) ./configure -enable-icap-support
> ............

 To enable icap support for squid3 use the "--enable-icap-client"
command line parameter:
./configure --enable-icap-client

Regards,
   Christos
Received on Tue Sep 11 2007 - 01:32:39 MDT