On Sat, 13 Dec 2003, Simon Walters wrote:
> I am very new to squid, and I was following the instructions in
>a manual to make squid ask for a username/password. It said squid
>came with a programme called ncsa_auth, but when I looked for it,
>I couldn't find it anywhere. I did a locate, but it could only find
>two files in the source folder. Where do I get ncsa_auth from?
When you compile Squid, you must add this option when you run configure:
./configure --enable-basic-auth-helpers=NCSA ...
If you didn't compile Squid (i.e., you used an RPM or something)
then you should probably get the source code and compile it from
the start.
Duane W.
Received on Fri Dec 12 2003 - 17:05:41 MST
This archive was generated by hypermail pre-2.1.9 : Thu Jan 01 2004 - 12:00:11 MST