On Wed, 15 Dec 2004, Mark Foster wrote:
> Well, it's been a while but prompted into further action by requests for
> more information from Michael Dunnell <mdunnell@cox.net> and Simon
> Thoustrup <simon@thoustrup.dk> we have now put our changes together for
> your consideration.
Excellent!
> This is a patch to enable WCCPv2 Layer2 redirection on squid. The patch was
> made for 2.5.STABLE5 but 'patch' offsets the hunks and it does apply
> cleanly to 2.5.STABLE7 which we have then successfully built and run.
>
> This patch is based on a combination of the other wccpv2 patches that
> already exist, particularly (IIRC) the visolve-WCCPv2 patch that is
> referenced at squid.org. The tricky bits like actually making the code
> changes, extensions and getting it to work for us are the work of James
> Goodlet.
Any chance we could get some help from you guys (primarily James I
suppose) in updating the patch to Squid-3, allowing us to integrate the
support into the Squid release?
We will make sure the current patch is maintained for Squid-2.5, but some
changes is likely required to update the patch to Squid-3 and in addition
our abilities to test this is quite limited due to lack of an WCCPv2 test
environment.
> The rest of this message body consists of notes relating to the required
> router configuration and squid.conf settings. The attachments are
> 'squid.INSTALL.USCS' which are the local build instructions that we use
> and, of course, 'wccpv2-L2.patch' which is the patch itself.
Is it OK if we reuse these instructions in the Squid FAQ on how to
configure WCCPv2?
Regards
Henrik
Received on Wed Dec 15 2004 - 04:59:29 MST
This archive was generated by hypermail pre-2.1.9 : Fri Dec 31 2004 - 12:00:05 MST